Marine Grade Structural Adhesive & Sealant

M-1 Marine Grade Structural Adhesive & Sealant

M-1 Marine is a moisture cure polyether adhesive/sealant formulated for applications above or, post cure, below the water line and in areas where outgassing and solvents are not tolerated. The product is solvent free and contains no isocyanates. It will not shrink upon curing, will not discolor when exposed to ultraviolet light, and will not "out-gas" or bubble on damp surfaces as urethane sealants often do. The sealant has resilient elastomeric properties and excellent adhesion to most substrates. It can be used effectively in many difficult site conditions, cures in wet or dry climates, and low temperatures.

Purchase chemlink products

Advantages

  • 100% VOC Compliant
  • Tough elastomeric bonds
  • Solvent Free
  • Fast Setting
  • High adhesion
  • Paintable within 24 hours
  • Gun grade, no special tools or mixing required
  • Can be applied at temperatures as low as 32°F (0°C)

Standards and Compliance

  • Conforms to OTC Rule for Adhesives
  • Meets requirements of California Regulations: CARB, SCAQMD, and BAAQMD
  • This product does not contain cancer causing chemicals listed in California Proposition 65
  • VOC Content: Less than 20 grams per liter
  • ASTM D-2369, EPA Method 24

Packaging

  • 3 oz (88 ml)
    12 squeeze tubes/carton, 48 cartons/pallet
  • 10.1 oz (300 ml)
    12 cartridges/carton, 105 cartons/pallet
  • 20 oz (600 ml) available by special order
    12 sausages/carton, 45 cartons/pallet
  • 5 gallon pails or 50 gallon drums
    available by special order